Remington 476 Manuale Utente Scaricare il pdf (Pagina 8)

8

Safety Precautions

4. NEVER drive fasteners into thin or

easily penetrated materials unless

it is backed by concrete or steel.

When in doubt, such as when base

material is concealed, conduct a

Center Punch Test. Check continu-

ally to avoid fastening into unsuit-

able material, especially in older

buildings.

5. DO NOT fasten thru or within 13mm

(1/2”) of predrilled or pre-punched

holes.

6. DO NOT drive fasteners into con-

crete less than three times as thick

as the intended fastener penetra-

tion, within 76mm (3”) of the edge,

within 76mm (3”) of another fas-

tener or within 76mm (3”) of a failed

fastener.

7. DO NOT drive fasteners into steel

base material less then 5mm

(3/16”) thick, within 51mm (2”) of a

weld, within 13mm (1/2”) of the

edge or within 25mm (1”) of another

fastener.

8. When fastening into masonry walls,

always drive into horizontal mortar

joints, NEVER into vertical mortar

joints. BE CAREFUL, a poorly laid

joint may permit too much penetra-

tion, and/or unsatisfactory holding

power.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Commenti su questo manuale

Nessun commento